Why do you change parts that are ok? Remove the chopper and look at base waveform. Should be 2v p-p squarewave. If ok look otherside of T4102 for problem. if squarewave not clean look to tea2261 and support circuits (cr4122 #200158 will check ok but fails under load LOTS ). I use a 10 cent ic socket for u4101. Seen Cr4119 fail LOTS because of bad audio output ic. Rick Mitchell M.H.E.S.C. Mitchstv@xxxxxxxxxx Lincoln, Nebraska ----- Original Message ----- From: "tvservice" <tvservice@xxxxxxxxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Tuesday, October 15, 2002 11:39 AM Subject: [TechAssist] Re: RCA P46151wk ctc169PTA Dead Set > > Have you checked CR4101 and CR4106 they will get leaky unsolder to check. > Also chec C4118 470mfd and R4003 33k ohm 2watt. > Robert > tvservice@xxxxxxxxxxxxxxxxxxx > H & H Electronics Inc > > ----- Original Message ----- > From: "Dave" <azevedod@xxxxxxxxxxx> > To: <techassist@xxxxxxxxxxxxx> > Sent: Monday, October 14, 2002 5:53 PM > Subject: [TechAssist] Re: RCA P46151wk ctc169PTA Dead Set > > > > > > Yes all were replaced along with U4101. Still get the same voltage > > measurements. > > Dave > > > > -----Original Message----- > > From: techassist-bounce@xxxxxxxxxxxxx > > [mailto:techassist-bounce@xxxxxxxxxxxxx]On Behalf Of Shoreline > > Electronics > > Sent: Tuesday, October 08, 2002 3:31 PM > > To: techassist@xxxxxxxxxxxxx > > Subject: [TechAssist] Re: RCA P46151wk ctc169PTA Dead Set > > > > > > > > Did you change : > > > > Cr4118 (Ecg580 Or Equiv) > > C4102 2.2uf 100v > > C4104 15uf 63v > > C4108 47uf 50v ( Sometimes This Is A 39uf) > > > > > > Jeff Stielau > > Shoreline Electronics Repair > > 125 Beech Tree Lane > > Westbrook, CT 06498 > > 860-399-1861 > > 860-664-3535 (fax) > > jstielau@xxxxxxxx > > ----- Original Message ----- > > From: "Dave" <azevedod@xxxxxxxxxxx> > > To: <techassist@xxxxxxxxxxxxx> > > Sent: Tuesday, October 08, 2002 4:13 PM > > Subject: [TechAssist] RCA P46151wk ctc169PTA Dead Set > > > > > > > > > > This is a dead set. Raw B+ is 160, 5v stby is 2.4v when first plugged > in > > > then drops to 0v. u4101 pin 16 vcc is only 9.0v as is v+ instead of the > > > 11.4v. > > > Any suggestions would be appreciated. > > > Thank you in advance. > > > Dave > > > Dave's Puters and video > > > azevedod@xxxxxxxxxxx > > > > > > ------------------------------------------ > > > To REMOVE your email address, click here: > > > http://www.tech-assist.org/unsubb.html > > > To CHANGE your email address, click here: > > > http://www.techassist.net/forms/change.html > > > ------------------------------------------ > > > ***NEW*** Tips Added Instantly!!!*** > > > Submit Repair Tips here: > > > http://www.tech-assist.org/secure/tip/ > > > > > > > > > > ------------------------------------------ > > To REMOVE your email address, click here: > > http://www.tech-assist.org/unsubb.html > > To CHANGE your email address, click here: > > http://www.techassist.net/forms/change.html > > ------------------------------------------ > > ***NEW*** Tips Added Instantly!!!*** > > Submit Repair Tips here: > > http://www.tech-assist.org/secure/tip/ > > > > ------------------------------------------ > > To REMOVE your email address, click here: > > http://www.tech-assist.org/unsubb.html > > To CHANGE your email address, click here: > > http://www.techassist.net/forms/change.html > > ------------------------------------------ > > ***NEW*** Tips Added Instantly!!!*** > > Submit Repair Tips here: > > http://www.tech-assist.org/secure/tip/ > > > > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/