I have Automan if that is necessary. Just a scan of the horizontal sweep and pincushion circuits should be sufficient. Need help. Thanks to all. Dominic DiLeo Atlantic TV Freeport, Maine ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ In a message dated 9/28/2005 2:58:59 PM Eastern Daylight Time, MDileo0000@xxxxxxx writes: Set has severe overscan and horizontally bowed pix. Found a cracked board and open foil pattern thru the pincushion section that apparently blew some components. I already replaced Q414(shorted), R415(open) and C415(shorted and vented). Scope shows a good parabola drive to Q414. Checked: D411, 412, C411, C413, C414 and L413. I need to look at a schematic. Any help or sm much appreciated on this Wal*Mart special. Dominic DiLeo Atlantic TV Freeport, Maine ----------------------------------------------------------------------------- This Email List is accessible to the general public through search engines. Remove: http://www.tech-assist.org/remove.htm Set Vacation mailto:ecartis@xxxxxxxxxxxxx?subject=set%20techassist%20vacation Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/