Junior, Pin 52 is the vert. out on IC 101. The waveform should be 4.6vp-p(5ms) on pin 52. I see you've already replaced C455, also replace C451(220m-16v) off of pin 1 of output IC, if you don't replace both these caps when replacing the output IC, the new output can fail immediately at turn on. Also, use only a Panasonic original LA7836. HTH Dan Webster Webster's TV Shullsburg, Wi. ----- Original Message ----- From: "junior hurdle" <jselectronics@xxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Wednesday, July 09, 2003 11:02 PM Subject: [TechAssist] Quasar TV model#SP2716K no vertical > Hi techs, > I am working on this Quasar tv model# Sp2716K which has no vertical . > I replaced the vertical output LA7836 and C455 (100mf) . this did not correct the problem. > There is no signal going into the vertical op ic. > Can any one tell me which pin on ic101 (AN5163K) is the vertical drive? > Junior hurdle. > **************************************************************************** * > CHECK OUT THE NEW CHATROOM! Just login and click on chat! > http://www.tech-assist.org/secure/tip/main.htm > The Tech Address Book: > http://www.tech-assist.org/secure/tip/contact.htm > Add a Repair Tip Here, or Change/Remove your Email Address: > http://www.tech-assist.org/secure/tip/main.htm > Lost Password: > http://www.tech-assist.org and select "Lost your Login Info?". > Email Archives: > //www.freelists.org/archives/techassist/ > ***************************************************************************** CHECK OUT THE NEW CHATROOM! Just login and click on chat! http://www.tech-assist.org/secure/tip/main.htm The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/