Does this have 2 separate boards & chassis's? ..... 1 for signal & the other for sweep & PS Is so......once you remove the wood screw that secures it to the wood case ( Right rear side of sweep board looking from the back).....pull firmly. The metal frame uses a V type notch that catches on a few cabinet mounted studs. Last Pioneer I did seemed stuck also & this was the case. Jeff Stielau Shoreline Electronics Repair 125 Beech Tree Lane Westbrook, CT 06498 860-399-1861 860-664-3535 (fax) jstielau@xxxxxxxx ----- Original Message ----- From: "Lyles Tv" <tech@xxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Saturday, September 14, 2002 12:03 PM Subject: [TechAssist] Pioneer SD-P5053 Chassis removal > I am embarassed to say that I cannot figure out what is securing the chassis in place. It seems to pivot somewhere in the middle, as if there is a single screw holding it in, but I can't figure which one. TIA > Jeff Farnsworth > Lyles TV and Appliance > 17 S Washington St > Elkhorn, Wi. 53121 > ph 262-723-3477 > fax 262-723-3658 > tech@xxxxxxxxxxx > > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ > > ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/