Larry isn't there a manual convergence board on the 169's al marquardt ampm@xxxxxxx ----- Original Message ----- From: "Larry E." <videotech@xxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Friday, December 06, 2002 10:46 AM Subject: [TechAssist] PTK169 PA More headaches > > Hi guys, After fixing the HV regulator board in this set, I took the > lightbox back and installed it and the picture is too wide, menu is > too far to the left, I`m ASSuming it`s C4402 and CR4402 which I`m going > to go out and replace today. Second problem is, blue convergence was off > so I tried to go into the menu and touch it up but the convergence page > isn`t there? I looked under "video" and "set-up" and it`s missing, I`ve > seen this on Zeniths but never on a 169 chassis any ideas ? tia, Larry E > > -- > Larry Eastman > American TV & Electronics > Crystal River, Fl. > http://www.tvjunkyard.com > > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > To CHANGE your email address, click here: > http://www.techassist.net/forms/change.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ > > ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/