Change these...do not bother to check. --------------------------------------------------------------- Text pasted from WinSTIPS 2.0 http://www.ServiceSoftware.com --------------------------------------------------------------- MITSUBISHI VZ7 Poor Vertical Sync Jeff Stielau : 10/28/03 : Shoreline Electronics Repair 1. VERTICAL ROLLING, VERTICAL BLANKING BAR LOCKING IN THE MIDDLE OF THE PICTURE, ALSO MAY HAVE HORIZONTAL PULLING OR TEARING. CHECK C2C52 10 UFD @ 50 V OFF THE BASE OF Q2C51 ON THE SIGNAL PCB. Located under metal shield in the center of the set. 2. CHECK C2P05 100 UFD 16 V OFF PIN 3 OF IC2P01 (9-VOLT REGULATOR) ON THE SIGNAL PC --------------------------------------------------------------- ================================= Jeff Stielau Shoreline Electronics Repair 344 East Main Street Clinton,CT 06413 (860)399-1861 (860)664-3535 FAX jstielau@xxxxxxxx ================================= ----- Original Message ----- From: "Hugh @ Main TV" <maintv2004@xxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Thursday, September 30, 2004 2:58 PM Subject: [TechAssist] Needprint--Mits. VS45605 > Need print (PDF) whatever, VS45605 PTV, VZ7 family. Have vertical > jitter in pix., caps check ok in vertical, put in new vert chip. > Checked ESR on C2p05 > cap as per WinStips. > TIA > Hugh Thornley > maintv2004@xxxxxxxxxxx > Main TV > 636 Main St > Longmont, Co 80501 > 303-776-6955 Tel > 303-776-0792 Fax > > ----------------------------------------------------------------------------- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/