Recapping the small usual culprits on the power supply board and rebuilding the vertical sweep circuit should take care of it.......along with a good thorough reflowing of solder on all the high temp areas. I'm sure you know the usual caps to change.....and more! If not...... shout back. ========================== Jeff Stielau Shoreline Electronics Repair 344 East Main Street Clinton,CT 06413 860-399-1861 860-664-3535 (fax) jstielau@xxxxxxxx ======================== "If you push something hard enough it will fall over." Fudd's First Law of Opposition - Sir Sidney Fudd ----- Original Message ----- From: "al m" <ampm@xxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Thursday, April 08, 2004 6:13 PM Subject: [TechAssist] Mitsubushi PTV VS4506 Manual needed. > Does anyone have a Service manual for this unit? It is shutting down. I now > have the boards and am changing the bad caps on them. If it keeps shutting > down will probably need manual. Thanks. > Al Marquardt > ampm@xxxxxxx > Al Marquardt Electronic Repair > 206 W Main > Girardville Pa. 17935 > > > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/