With the remote,do menu 1359,that will get the convergance adjustments. -----Original Message----- From: techassist-bounce@xxxxxxxxxxxxx [mailto:techassist-bounce@xxxxxxxxxxxxx] On Behalf Of Ttkirkpat@xxxxxxx Sent: Thursday, September 26, 2002 1:07 PM To: techassist@xxxxxxxxxxxxx Subject: [TechAssist] Mitsubishi projection model VS-5043- convergence Convergence ic's were bad- center and outer 4 digital adjustments set perfectly. Now the question- the red horizontal outer edges look like they would need to be touched up ( like the linearity and size controls on other convergence boards ). Is there a way to access the memory on this digital unit to do this ?? Thanks for help from Mike at the Video Center. My e-mail is ttkirkpat@xxxxxxx ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/ ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.techassist.net/forms/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/