All three rasters are out, all low ohm resistors check good. Thanks Coach At Home TV Service 4975 W. 80th Westminster, CO 80030 ----- Original Message ----- From: Shoreline Electronics To: techassist@xxxxxxxxxxxxx Sent: Thursday, April 01, 2004 11:52 AM Subject: [TechAssist] Re: Mitsubishi VS50609 VZ9 bottom distortion Check the low ohm resistors in the circuit. Are all three rasters out? ================================= Jeff Stielau Shoreline Electronics Repair 344 East Main Street Clinton,CT 06413 (860)399-1861 (860)664-3535 FAX jstielau@xxxxxxxx ================================= ----- Original Message ----- From: "Coach @ AT HOME TV SERV" <lowboy20@xxxxxxx> To: "techassist_freelists_org" <techassist@xxxxxxxxxxxxx> Sent: Thursday, April 01, 2004 10:05 AM Subject: [TechAssist] Mitsubishi VS50609 VZ9 bottom distortion > We are working on this Mits with convergence distortion only at the bottom of the screen. We've replaced the STK393-110 convergence IC and soldered numerous bad connections on both boards. Supply is solid +27 -24. Advance convergence adjustments do not work in this area, they do everywhere else. > Any one have any ideas?? > Thanks > Coach > At Home TV Service > 4975 W. 80th > Westminster, CO 80030 > coach@xxxxxxxxxxxxxxxxxxx > > > -------------------------------------------------------------------------- --- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/