Neil, I'd check for open resistors on the conv. amp board. Had that more than once. I have the prints if you need some help with voltages or waveforms. Terry H. The TV Shop ----- Original Message ----- From: "Neil Bowman" <tvdoctors@xxxxxxxxxxxxx> To: <techassist@xxxxxxxxxxxxx> Sent: Friday, September 12, 2003 10:43 AM Subject: [TechAssist] Hitachi CU5000K Convergence problems > Convergence all out of whack. Cooling and heating of IC2101 on the convergence correction board makes major changes. I replaced this Ic with one that I bought through Tritronics but same exact thing. Anyone else have a problem with this on these hitachi's or is there a tip somewhere that discusses this. Just ordered a new Ic from another soarce to try but thought about getting input b4 it gets here. Neil > TV Doctors > Monroe,Wa. > **************************************************************************** * > Classifieds! Buy or Sell! > http://sell.tech-assist.org > The Tech Address Book: > http://www.tech-assist.org/secure/tip/contact.htm > Add a Repair Tip Here, or Change/Remove your Email Address: > http://www.tech-assist.org/secure/tip/main.htm > Lost Password: > http://www.tech-assist.org and select "Lost your Login Info?". > Email Archives: > //www.freelists.org/archives/techassist/ > > [Scanned by AwesomeNet Anti-Virus] > > [Scanned by AwesomeNet Anti-Virus] ***************************************************************************** Classifieds! Buy or Sell! http://sell.tech-assist.org The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/