I found two jumper wires (by accident) that were labeled H-Sync and V-Sync, and I traced them back to the signal cable. The customer had already soldered the R, G, and B wires (all color coded), so my job is now done. Kevin Wilks Kevin's TV & Video Repair Penticton BC Canada kevintv@xxxxxxx -----Original Message----- From: techassist-bounce@xxxxxxxxxxxxx [mailto:techassist-bounce@xxxxxxxxxxxxx] On Behalf Of Kevin Sent: Friday, August 13, 2004 4:44 PM To: TECH-ASSIST Subject: [TechAssist] Acana 17" Advance 17S, computer monitor, need wiring diagram of signal cable Customer tried to fix this himself by soldering in another signal cable. Unfortunately he did not use an ohm meter and got some of the wires wrong. I usually use the old signal cable end to figure out which wire goes where. Of course the customer threw out the old signal cable end which I now need! Kevin Wilks Kevin's TV & Video Repair Penticton BC Canada kevintv@xxxxxxx ------------------------------------------------------------------------ ----- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/