This set came in with regulator shorted. Replaced regulator with reg.kit and set lasted 3 weeks and came back with horizontal output shorted and cr14402 shorted. Found bad solder on drive transformer ( I know should have checked the first time) replaced and set came back 2 weeks later same problem. Found flyback had only 6 rings. Replaced flyback and now the timing is 12.3ms and the load test shows 86 ma which says bad on the sencore tester. The set runs good and the only pin that drops the load is the filament pin. My question is can anyone verify that 12.3ms is correct for this set and that 86ma is right also. I have no other sets to check to make sure. Thanks. Al Marquardt ampm@xxxxxxx Al Marquardt Electronic Repair 206 W Main Girardville Pa. 17935 ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/