Canon Cam E-210- (Same boards as the 63, 65 models) Problem -originally was dead. Replaced most caps in the 400 series and the 8-pin regulator IC. Now have power w/ all lens functions and good eject. Unit stays on as long as tape holder is open. Once tape (or shell) inserted and closed, there is no load activity; no drum rotation. 'Eject' flashes and unit shuts down. It will eject from this condition. Did check all connections and interconnects. Also tape -in switches. Going to swap tape deck to check drum motor. Anything else recommended? There is a drum driver IC and a wave shaper IC in drum ckt but don't want to start getting in that far Mr. Fix-It rogerfixit@xxxxxxxx; (alternate -(for attachments) - rogerfixit@xxxxxxxxxxxxx ) Roger G.; Harrisburg, PA 17110 FAX 801-705-3748 ; Tel: 717-763-7098 (shop) 717-652-1703(home) WebSite- http://mrfixit.netfirms.com ________________________________________________________________ GET INTERNET ACCESS FROM JUNO! Juno offers FREE or PREMIUM Internet access for less! Join Juno today! For your FREE software, visit: http://dl.www.juno.com/get/web/. ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html To CHANGE your email address, click here: http://www.tech-assist.org/change.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/