This was dead. Over near the flyback area on a heat sink I found shorted FET Q401: FS3KM18A. The 18 amp version of the FS3KM fet's. NTE crosses it to their NTE2387 which is only 16A rated. I also found a bulged cap, C334 (100mfd@250V). Replaced both parts (used an NTE2387). Unit powers on with normal display (a bit off center), and I can press menu, get the OSD, push button to select any function (size, centering, geometry, color drive,language,etc) but I cannot adjust anything.Nothing indicates it's doing something. No bars or numbers,no movement when the +,- is pressed,etc to make a change. I individually checked each tactile switch (OK) and very closely inspected for cracks (none) I wonder if the eeprom got corrupted when it went down. Is there a way to access the service menu, of at least reset it? Any other suggestions? So close... Phil Bader -- Philip Bader Jan Phyl TV Inc. (estab. 1976) 3420 Recker Hwy. Winter Haven, Fl. 33880 Fax (863) 299-8821 email: tjanphyl@xxxxxxxxxxxxxxx ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/