Hi phil the fet from mitsubishi is rated at 900v/3a please make a note of it Bill poulos our company Electronica 1-800-722-5578 In a message dated 8/7/2004 12:32:05 PM Mountain Daylight Time, tjanphyl@xxxxxxxxxxxxxxx writes: > Subj: [TechAssist] CTX 19" monitor PL9 (no FCC) dead, had bad Q401 and C334 > replaced, now can't adjust] > Date: 8/7/2004 12:32:05 PM Mountain Daylight Time > From: tjanphyl@xxxxxxxxxxxxxxx > Reply-to: techassist@xxxxxxxxxxxxx > To: techassist@xxxxxxxxxxxxx > Sent from the Internet > > > > > > This was dead. Over near the flyback area on a heat sink I found shorted > FET Q401: FS3KM18A. The 18 amp version of the FS3KM fet's. NTE crosses > it to their NTE2387 which is only 16A rated. > I also found a bulged cap, C334 (100mfd@250V). Replaced both parts (used > an NTE2387). > Unit powers on with normal display (a bit off center), and I can press > menu, get the OSD, push button to select any function (size, centering, > geometry, color drive,language,etc) but I cannot adjust anything.Nothing > indicates it's doing something. No bars or numbers,no movement when the > +,- is pressed,etc to make a change. > I individually checked each tactile switch (OK) and very closely > inspected for cracks (none) > I wonder if the eeprom got corrupted when it went down. > Is there a way to access the service menu, of at least reset it? > Any other suggestions? > So close... > Phil Bader > > -- > > Philip Bader > Jan Phyl TV Inc. (estab. 1976) > 3420 Recker Hwy. Winter Haven, Fl. 33880 > Fax (863) 299-8821 > email: tjanphyl@xxxxxxxxxxxxxxx > > > > > > > ----------------------------------------------------------------------------- > > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ > ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/