check the .012 cap on the crt neck board, and the transistor that it is connected to, I think its 5004, should be on the base, also the high voltage caps with 250 volt rating or so, that filter hv. will cause flickering, excessive brightness etc. near and around the flyback brock ----- Original Message ----- From: "Barry MacInnes" <foxhole@xxxxxxxxx> To: "Tech Assist" <techassist@xxxxxxxxxxxxx> Sent: Friday, September 05, 2003 6:55 AM Subject: [TechAssist] CTC177BH2 bright screen with retrace lines > Hello Techs, > This unit has bright screen with retrace lines,no video, audio is OK. There is no video out of RGB's on IC1oo1. No video at pin 63 of IC1001. Replaced IC1001 to no avail. 7.5v Ok. > Has anyone seen this failure? > Thank You > Barry > TV Service Clinic > W. Lebanon,NH > **************************************************************************** * > Classifieds! Buy or Sell! > http://sell.tech-assist.org > The Tech Address Book: > http://www.tech-assist.org/secure/tip/contact.htm > Add a Repair Tip Here, or Change/Remove your Email Address: > http://www.tech-assist.org/secure/tip/main.htm > Lost Password: > http://www.tech-assist.org and select "Lost your Login Info?". > Email Archives: > //www.freelists.org/archives/techassist/ ***************************************************************************** Classifieds! Buy or Sell! http://sell.tech-assist.org The Tech Address Book: http://www.tech-assist.org/secure/tip/contact.htm Add a Repair Tip Here, or Change/Remove your Email Address: http://www.tech-assist.org/secure/tip/main.htm Lost Password: http://www.tech-assist.org and select "Lost your Login Info?". Email Archives: //www.freelists.org/archives/techassist/