Jeff, I had one of those chassis's not too long ago doing exactlty the same thing and after replacing all of the things you mentioned, I found the red crt was bad.. pulled the crt board off and it started up ok.. Al Brown Largents inc. 718 main st. Lewiston , Id. 83501 208-743-8579 208-746-3426 fax Intrepid Video Support wrote: > Still working on this, can not figure out why it is shutting down as HV > builds. > Would a defective vertical section cause this set to shut down? > REG B+ is 170 in standby, drops to 162 when I press power..is this normal on > this set? > Schematic shows Reg B+ <72-A>, Not sure what that means. > I've repaired many of these with a splitter, flyback or replacing the parts > in the power supply. > I've done all this and set still shuts. I've replaced all the caps, the boxed > caps in front of the HOT, > CR4118(tested OK), U4101, Q4101, Q4401..and all the caps. Checked all the > diodes and resistors and can > find no problems. > I'm running out of time on this one....Does anyone have any idea what I may > have missed? > Thank you. > > Jeff Dougherty > Intrepid Video TV/VCR > 263 S Front St > Steelton PA 17113 > fax...717-564-4952 > www.intrepid-video.com www.tech-repair.net > > ----------------------------------------------------------------------------- > Lost Password: > http://www.tech-assist.org and select "Login Problems?". > Email Archives: > //www.freelists.org/archives/techassist/ ----------------------------------------------------------------------------- Lost Password: http://www.tech-assist.org and select "Login Problems?". Email Archives: //www.freelists.org/archives/techassist/