[TechAssist] Re: 2ND post[Fwd: IBM 2235-00N /Compaq 610,V50 (fcc# A3KM062, chassis CM1300) too wide,pin cush. no adjust.]
- From: "Jim Myers" <jr.myers@xxxxxxxxxxx>
- To: <techassist@xxxxxxxxxxxxx>
- Date: Fri, 5 Oct 2001 17:04:43 -0500
Just ran across this in WinsTips, different model, 2248R01 but also a
Philips chassis and same symptom, excessive width and pincushion problem.
Bad solder at L405 not sending signal to pincushion correction circuit. Give
it a look.
Jim Myers
jr.myers@xxxxxxxxxxx
----- Original Message -----
From: "Phil Bader" <philbad@xxxxxxxxxx>
To: <techassist@xxxxxxxxxxxxx>
Sent: Friday, October 05, 2001 4:12 PM
Subject: [TechAssist] 2ND post[Fwd: IBM 2235-00N /Compaq 610,V50 (fcc#
A3KM062, chassis CM1300) too wide,pin cush. no adjust.]
>
>
>
> -------- Original Message --------
> Subject: IBM 2235-00N /Compaq 610,V50 (fcc# A3KM062, chassis CM1300) too
> wide,pin cush. no adjust.
> Date: Fri, 05 Oct 2001 17:10:31 -0400
> From: Phil Bader <philbad@xxxxxxxxxx>
> Organization: Jan Phyl TV Inc. Winter Haven, Fl. Estab. 1976
> To: "ELREPAIR-L@xxxxxxxxxxxxxxxxxxxx" <ELREPAIR-L@xxxxxxxxxxxxxxxxxxxx>
>
> 15 inch monitor.I have checked all FET's, scan caps not shorted.It is
> too wide and bowed at sides and cannot adjust. No reaction. All other
> parameters can be adjusted (H.cent,V.pos,hgt. Brt,cont). Everything
> seems to run cool.On other units I suspect a shorted scan cap. This
> seems to be present on all scan mode freqs.This model is the same as a
> Philips chassis CM1300. Heeeeelp! ;-0 Phil
> Help make your TechAssist online repair tips
> database better! Submit your fixes here:
> http://www.circuitwork.com/techassist/tip/#tips
> To unsubscribe write to:
> techassist-request@xxxxxxxxxxxxx
> with unsubscribe in the subject line.
Help make your TechAssist online repair tips
database better! Submit your fixes here:
http://www.circuitwork.com/techassist/tip/#tips
To unsubscribe write to:
techassist-request@xxxxxxxxxxxxx
with unsubscribe in the subject line.
Other related posts:
