Bill: Replace c 353 at power supply board. Hope this will fix it. Very common problem. Frank --- Bill S <billans@xxxxxxxxxxxx> wrote: > > Hi all; > We have two of these units; Viewsonic 21" PS 810 > FCC# GSS21010 Chassis# > 21VS001 > Will not turn on. I checked for obvious shorts and > nothing. Checked and > repaired numerous bad solder connections with some > connections being quite > bad. When this unit was upside down on its face and > partially assembled > after doing the numerous solder touch up, this unit > would turn on and off > every single time I powered it up. > I re-assembled the ground covers and the cabinet and > tried it and nothing. > I then pushed the power button a couple of more > times and it came on again. > The current meter shows a small difference when it > comes on as versus it not > coming on. Its almost like it wants too, but > cannot. This unit chassis is > a bear to try to run without it being assembled. > Any ideas? > Thanks > Bill Sorensen > New Life Video & Audio > billans@xxxxxxxxxxxx > - - - - - - - - - - - - - - - - - - - > > > > > ------------------------------------------ > To REMOVE your email address, click here: > http://www.tech-assist.org/unsubb.html > ------------------------------------------ > ***NEW*** Tips Added Instantly!!!*** > Submit Repair Tips here: > http://www.tech-assist.org/secure/tip/ __________________________________________________ Do You Yahoo!? LAUNCH - Your Yahoo! Music Experience http://launch.yahoo.com ------------------------------------------ To REMOVE your email address, click here: http://www.tech-assist.org/unsubb.html ------------------------------------------ ***NEW*** Tips Added Instantly!!!*** Submit Repair Tips here: http://www.tech-assist.org/secure/tip/