Sweet.
Now, if you could only print the motor.....
------------------------------------------------------------------------
*From:* Matt Powell <mattp@xxxxxxxxxxxx>
*To:* tccrockets@xxxxxxxxxxxxx
*Sent:* Wed, June 15, 2011 6:37:10 AM
*Subject:* [tccrockets]
Thanks for the response for the D12-5. Attached is a photo of the 3D
printed rocket 14” tall ABS plastic. Kenneth Rock sim has it at 880ft
on the D12-5. It was printed in four sections – Nose cone, nose cone
shoulder, body tube 5” long, fins w/ motor housing.
Matthew Powell
