ok so i am putting in a new tie rod tonight and am planning on aligning it
while i am at it.
so the bently says that the front of the front tires should be in more than
the rear of the front tires. how much? bently gets all garbldy gooked up
after it says the front of the front should be in more than the back of the
front. i will be doing all this with two tape measures duct tape and chalk
to mark my measuring spots. after of course i get the rod in.
i have been told 1/16" is this true if not then how much.
also any good grease to use on the ends?