Hi Don,
You can put a plus sign (+) or minus sign (-) before the specified time to move relative
to the current position. You can also just hit = and SR will fill in the "+"
for you and remember your last offset. Example:
1. press = (which is the plus sign unshifted)
2. type 44:15
3. Press Enter.
In the future, you can just hit = and Enter to make the same jump.
You can also hit - instead of = to move back.
Marking the start of each side is also a good idea. If you are using Milestones
(on by default), there is already a mark at the beginning of each subrecording
in the file.
Rob
-----Original Message-----
From: studiorecorder-bounce@xxxxxxxxxxxxx
[mailto:studiorecorder-bounce@xxxxxxxxxxxxx] On Behalf Of Donald L. Roberts
Sent: Wednesday, October 09, 2013 11:00 AM
To: studiorecorder@xxxxxxxxxxxxx
Subject: [studiorecorder] question about the go to command
In my volunteer work, I transfer materials recorded on tape cassette to the
hard drive using studio recorder. I record all of the tracks on a casette to
one large file on the hard drive. The audio on each track is typically
approximately 44 minutes 15 seconds in length.
I am wondering whether there is any way using this command to move within the
recorded material plus or minus 44 minutes 15 seconds. As it now stands, if I
understand the command's use correctly, I must determine the cursor's current
position and then add or subtract 44 minutes 15 seconds from that total.
Thanks for any feedback.
Don Roberts
