[SI-LIST] Using Eye diagram for finding setup and hold time
- From: Amit Kumar <Amit.Kumar@xxxxxxxxxxx>
- To: "si-list@xxxxxxxxxxxxx" <si-list@xxxxxxxxxxxxx>
- Date: Fri, 1 Mar 2013 06:22:38 +0000
Hello Experts,
Is it safe to use eye diagrams to find setup and hold time between clock and
data?
I am not very sure because I think the minimum value of setup/hold time which
we get may not be the actual case as in the eye diagram we do not know which
clock signal correspond to which data signal.
Can this method be safely used to find out the exact setup/hold time values or
there are some shortcomings of this method?
Regards
Amit
________________________________
PLEASE NOTE: The information contained in this electronic mail message is
intended only for the use of the designated recipient(s) named above. If the
reader of this message is not the intended recipient, you are hereby notified
that you have received this message in error and that any review,
dissemination, distribution, or copying of this message is strictly prohibited.
If you have received this communication in error, please notify the sender by
telephone or e-mail (as shown above) immediately and destroy any and all copies
of this message in your possession (whether hard copies or electronically
stored copies).
------------------------------------------------------------------
To unsubscribe from si-list:
si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field
or to administer your membership from a web page, go to:
//www.freelists.org/webpage/si-list
For help:
si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field
List forum is accessible at:
http://tech.groups.yahoo.com/group/si-list
List archives are viewable at:
//www.freelists.org/archives/si-list
Old (prior to June 6, 2001) list archives are viewable at:
http://www.qsl.net/wb6tpu
Other related posts:
