Hi all, I am trying to find a way to switch a TMDS 50 ohm to 3.3V termination on/off without interfering with the TMDS operation when in the off state. This is the TMDS clock signal and the clock rate is 250MHz max. When in the on state there will be no termination at the receiving end and when in the off state there will be a termination at the receiving end. Is there a way to do this and still maintain 50 ohm impedance at 2.5GHz? Regards, Mark ------------------------------------------------------------------ To unsubscribe from si-list: si-list-request@xxxxxxxxxxxxx with 'unsubscribe' in the Subject field or to administer your membership from a web page, go to: //www.freelists.org/webpage/si-list For help: si-list-request@xxxxxxxxxxxxx with 'help' in the Subject field List technical documents are available at: http://www.si-list.net List archives are viewable at: //www.freelists.org/archives/si-list or at our remote archives: http://groups.yahoo.com/group/si-list/messages Old (prior to June 6, 2001) list archives are viewable at: http://www.qsl.net/wb6tpu