Be sure to mark the position of the plate before removal. BP ________________________________________ From: sac-forum-bounce@xxxxxxxxxxxxx <sac-forum-bounce@xxxxxxxxxxxxx> on behalf of Bill VanOrden <beevo1@xxxxxxx> Sent: Sunday, March 1, 2015 3:49 PM To: sac-forum@xxxxxxxxxxxxx Subject: [sac-forum] Re: Removing a Stubborn C11 Corrector Plate I had a few on the LX series that were stuck pretty well. I used the output of a shop vac and pressurized it a bit. Make sure there is someone there to catch it when it pops off. Obviously the shop vac needs to be new or really clean..... -----Original Message----- From: sac-forum-bounce@xxxxxxxxxxxxx [mailto:sac-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Tom Polakis Sent: Sunday, March 01, 2015 2:44 PM To: sac-forum@xxxxxxxxxxxxx Subject: [sac-forum] Removing a Stubborn C11 Corrector Plate I need to remove the corrector plate on my C-11 before I try to sell it. After removing the retaining ring, it did not want to budge. Has anybody else had this problem, and if so, found a solution? If not, I'll see what we can do at Paul's ATM meeting this Tuesday. Thanks. Tom