My dry-mount temperature is 80-90C for RC and 90-100C for FB. I have to state a range, because you don't get a constant temperature from a dry-mount press. Regards Ralph W. Lambrecht http://www.darkroomagic.com On 2006-04-19 15:42, "Shannon Stoney" <sstoney@xxxxxxx> wrote: >> Shannon >> >> I use the same temp as for dry-mounting for 2 minutes between two pieces of >> mat-board. Then I take it out and cool it under a heavy piece of glass for 5 >> minutes. Aluminum may be a better heat conductor, but glass works fine and >> is easier to get get and to keep clean. > > > What is your dry mounting temperature? > > --shannon > >> >> >> >> >> >> Regards >> >> >> >> Ralph W. Lambrecht >> >> http://www.darkroomagic.com >> >> >> >> >> >> >> >> On 2006-04-19 03:06, "Shannon Stoney" <sstoney@xxxxxxx> wrote: >> >>> I think I am going to check the temperature that that dry mount press >>> I have been using gets to. It doesn't seem to get very hot to me. >>> But, what is the right temperature for flattening prints? >>> >>> --shannon >>> >>> >>> ============================================================================ >>> == >>> =============================== >>> To unsubscribe from this list, go to www.freelists.org and logon to your >>> account (the same e-mail address and password you set-up when you >>> subscribed,) >>> and unsubscribe from there. >> >> >> ============================================================================= >> ================================ >> To unsubscribe from this list, go to www.freelists.org and logon to >> your account (the same e-mail address and password you set-up when >> you subscribed,) and unsubscribe from there. > > ============================================================================== > =============================== > To unsubscribe from this list, go to www.freelists.org and logon to your > account (the same e-mail address and password you set-up when you subscribed,) > and unsubscribe from there. ============================================================================================================= To unsubscribe from this list, go to www.freelists.org and logon to your account (the same e-mail address and password you set-up when you subscribed,) and unsubscribe from there.