Awhile back someone suggested using a heating pad. I would suggest using a ground fault outlet in connection with this although modern heating pads are sealed in plastic. -----Original Message----- From: pure-silver-bounce@xxxxxxxxxxxxx [mailto:pure-silver-bounce@xxxxxxxxxxxxx] On Behalf Of Gianni Rondinini Sent: Friday, April 07, 2006 3:37 AM To: pure-silver@xxxxxxxxxxxxx Subject: [pure-silver] how to keep paper chemicals warm? at the moment i'm heating chemicals before i begin printing and then let them cool down during the whole print session (which means at least 3 hours to get a decent print, then i wash everything and i go to bed - yep, i know i'm really poor in darkroom... :) this is because i don't have anything to keep them warm. in this way, chemicals are, say, at 22°c when starting the whole thing and their temperature drops to 18 or less during the time. i've read on "the print" by adams that he used a huge thermostatic sink with the 3 bath and everything else immersed in it, but i can't adopt this solution because of space and another number of reasons. what do you use to keep the baths' temperature circa-constant? thanks in advance. -- Gianni Rondinini (30, tanti, RA) Nikon user - Bmw driver http://bugbarbeq.deviantart.com ====================================To unsubscribe from this list, go to www.freelists.org and logon to your account (the same e-mail address and password you set-up when you subscribed,) and unsubscribe from there. ============================================================================================================To unsubscribe from this list, go to www.freelists.org and logon to your account (the same e-mail address and password you set-up when you subscribed,) and unsubscribe from there.