I have a Deardorff 4x5 Special and use a metal board for the Graphic View. I also use a view to speed adaptor that allows me to use lenses mounted on speed/crown graphic boards w/ my Deardorff. These would have to be purchased used since they are no longer produced. On Sep 9, 2004, at 8:39 PM, Alan Bucknam wrote: > Ok, here's my stupid question for the day (ok, my *tenth* stupid > question for the day...just the first one directed at y'all): > > Are there any metal lensboards that are compatible with the Deardorff > ~4x~4-inch lensboard openings (Mine's a 5x7 'dorff)...like a > Sinar/etc.? I regularly (accidentally) beat the snot out of the corners > of the wooden ones, and I'd like to know if anyone's had any luck with > using a non-Deardorff board on a Deardorff. > > If that's not possible, are there specs out there in the infosphere > that would allow my good machinist to create a stainless-steel > lensboard to the proper specifications? > > thanks, > > Alan Bucknam > > ======================================================================= > ====================================== > To unsubscribe from this list, go to www.freelists.org and logon to > your account (the same e-mail address and password you set-up when you > subscribed,) and unsubscribe from there. ============================================================================================================= To unsubscribe from this list, go to www.freelists.org and logon to your account (the same e-mail address and password you set-up when you subscribed,) and unsubscribe from there.