The following new message has been posted on Phorm Support Forum at <http://www.phorm.com/support/>. *************************************************************************** MESSAGE: (#3002) Re: Using EXISTS <http://www.phorm.com/support/?rev=3002> AUTHOR: Holotech DATE: July 19, 2003 at 8:52 a.m. EST Reply To: (#3000) Using EXISTS Author: Rich Date: July 18, 2003 at 3:18 p.m. EST > When I use EXISTS to check a database table, and the > data that is being checked does exist in the table, is > there a way for it NOT to log the data in the table > when it is checking? Since I already have it there, it > would be helpful. That should be the normal behavior. When validation fails on a rule with an error level higher than 0, processing terminates and there should be no logging. Are you experiencing something else? *************************************************************************** This is an automatically-generated notice. If you'd like to be removed from the mailing list, please visit Phorm Support Forum at <http://www.phorm.com/support/>, or send your request to webbbs@xxxxxxxxxx If you wish to respond to this message, please post your response directly to the board. Thank you! ------------------------------------------------- You are receiving this message because you are subscribed to the Phorm mailing list. To send messages to the mailing list, simply send email to phorm@xxxxxxxxxxxxx from the address you have subscribed. You may unsubscribe from the list by sending email to phorm-request@xxxxxxxxxxxxx with 'unsubscribe' in the SUBJECT field.