I'm seeing a problems with ep9307 MAC sometimes reporting rx frame length smaller than it should be. The u-boot prints something like this: BOOTP broadcast 42 DHCP client bound to address 10.254.254.10 TFTP from server 10.254.254.1; our IP address is 10.254.254.10 Filename 'arm.uImage'. Load address: 0xf0001000 Loading: T T len bad 56 < 57 T len bad 84 < 85 T len bad 84 < 85 len bad 64 < 65 T T T T T T ################################################################# ################################################################# ######################### done I've narrowed it down to rx_status_q->frame_length showing 1 byte less than what the sniffer shows and what the ip_pkt.len + 14 equal to. What could make ep93xx core do that? Thanks, - Ben DISCLAIMER: Important Notice ************************************************* This e-mail may contain information that is confidential, privileged or otherwise protected from disclosure. If you are not an intended recipient of this e-mail, do not duplicate or redistribute it by any means. Please delete it and any attachments and notify the sender that you have received it in error. Unintended recipients are prohibited from taking action on the basis of information in this e-mail.E-mail messages may contain computer viruses or other defects, may not be accurately replicated on other systems, or may be intercepted, deleted or interfered with without the knowledge of the sender or the intended recipient. If you are not comfortable with the risks associated with e-mail messages, you may decide not to use e-mail to communicate with IPC. IPC reserves the right, to the extent and under circumstances permitted by applicable law, to retain, monitor and intercept e-mail messages to and from its systems.