if you need it again, it is in the outlook express helpful hints section on the helpful hints page. The following script change applies to Jaws 3.7U and later. You want to comment out a line in the jawsdelete script, but unfortunately it isn't in the script list because they didn't add the documentation back. But here is how to do it. In OE press insert 0 to open the OE script file. Press control F for the find dialog and type in jawsdelete exactly like that without a space and hit enter. When it reports it found it, press escape. Arrow down to the line that reads SayMessage (ot_STATUS, msg_DeleteMessage_L, msg_DeleteMessage_S) and put a semicolon in front of the line. So it is like this ; SayMessage (ot_STATUS, msg_DeleteMessage_L, msg_DeleteMessage_S) Press control S to compile the script. Press alt f4 to leave the script manager. Hope this is what you are looking for, I agree that message deleted statement is an annoyance. Also, You should be able to toggle the BCC field on and off by pressing Alt B. Good luck. -- To post a message to the list, send it to jfw@xxxxxxxxxxxxx To unsubscribe from this mailing list, send a message to jfw-request@xxxxxxxxxxxxx with the word unsubscribe in the subject line. Archives located at: //www.freelists.org/archives/jfw If you have any concerns about the list, post received from the list, or the way the list is being run, do not post them to the list. Rather contact the list owner at jfw-admins@xxxxxxxxxxxxxx