Al,Did you try using the Jaws cursor? And you should be able to check the progress by reading the status lline. Richard Justice ----- Original Message ----- From: "Al Puzzuoli" <apuzzuoli@xxxxxxxxxxx> To: <jfw@xxxxxxxxxxxxx> Sent: Friday, July 16, 2004 7:45 PM Subject: Questions about Disk Keper Light? > Hi, > I recently downloaded and have begun using Disk Keeper light. > The first time I used it, I was curious as to what level of defragmentation it would find on my HD. I chose the analyze option, but could find no way to read the results of the analysis. > Similarly, I chose the defrag option, but then couldn't see a way to determine the percentage of the process that had been completed or whether the process had actually finished. > If there's any way to do this I would much appreciate the info. > Thanks, > > > -- > To post a message to the list, send it to jfw@xxxxxxxxxxxxx > To unsubscribe from this mailing list, send a message to jfw-request@xxxxxxxxxxxxx with the word unsubscribe in the subject line. > Archives located at: //www.freelists.org/archives/jfw > > If you have any concerns about the list, post received from the list, or the way the list is being run, do not post them to the list. Rather contact the list owner at jfw-admins@xxxxxxxxxxxxxx -- To post a message to the list, send it to jfw@xxxxxxxxxxxxx To unsubscribe from this mailing list, send a message to jfw-request@xxxxxxxxxxxxx with the word unsubscribe in the subject line. Archives located at: //www.freelists.org/archives/jfw If you have any concerns about the list, post received from the list, or the way the list is being run, do not post them to the list. Rather contact the list owner at jfw-admins@xxxxxxxxxxxxxx