Hello, I have the same problem. I am using Windows-98 with the same version of Jaws as you. It tells me to hit the Windows application key and use the Jaws cursor to read the list view after tabbing to the list-view, but nothing happens. 0 I just started using control+s, control+n and when it finishes scanning and finds an object I type control+m, then after that message I control+n which brings me back to the main interface (on the status button), and close the program. The job seems to get done so I ignore that message. If someone can tell us how to fix the problem better I would appreciate the knowledge too. Cordially, EMK At 06:04 AM 07/09/04, you wrote: >Hi List, >I am running Windows 98 SE and Jaws 5.0.844. I have the scripts for Add >aware for Jaws 5.0 in the ENU folder. Now, when I go to begin the program, I >hit Control S like instructions say. As it goes along, I hear the messages, >scanning local registry etc. When I get the sound that I have one object, I >hit Control N and I get the message, not found, tab to list view and use >your Jaws curser and select all. I can't even find a list view choice. So, I >tried the thing again. Went through all the steps to the end was notified >that I have one object, this time I hit control M to see what would happen, >since control N didn't work, and I get the same message, not found tab to >list view and use jaws curser to select all. I have now decided I am the >dumbest person on this list. What the heck am I doing wrong. >frustrated, Jim > >-- -- To post a message to the list, send it to jfw@xxxxxxxxxxxxx To unsubscribe from this mailing list, send a message to jfw-request@xxxxxxxxxxxxx with the word unsubscribe in the subject line. Archives located at: //www.freelists.org/archives/jfw If you have any concerns about the list, post received from the list, or the way the list is being run, do not post them to the list. Rather contact the list owner at jfw-admins@xxxxxxxxxxxxxx