Hi..
This is what I tried..
#tar zxvpf USBNET_E2_LINUX_062802_REL1.7.tar.gz
#cd e2
#make
These are the contents of the directory 'e2'.
BlDefs.h e2.o hsbeth.o ntdef.h usb-uhci.h
BlSrv.c E2Setup.txt hsbusb.c SndRcv.c version
BlSrv.o FwInit.c hsbusb.o SndRcv.h WBoot.hex
cnxe2fw.bin.110502_rel10_E FwInit.h ioctl.c SndRcv.o
cnxthsb FwInit.o kmod.c usbsndcm.c
customer.h hasbani.h kmod.h usbsndcm.h
dhcpcd hsbeth.c Makefile usbsndcm.o
These are the contents of the directory e2source
BlDefs.h customer.h hasbani.h kmod.c Readme.txt usbsndcm.h
BlSrv.c dhcpcd hsbeth.c kmod.h SndRcv.c usb-uhci.h
CnxE2Fw.bin FwInit.c hsbusb.c Makefile SndRcv.h version
cnxthsb FwInit.h ioctl.c ntdef.h usbsndcm.c WBoot.hex
Then I ran the following command from the directory e2source
#cp CnxE2Fw.bin /etc/CnxE2Fw.bin
Then I ran the following command from the directory 'e2'
[root@localhost e2]# insmod e2.o
Warning: loading e2.o will taint the kernel: no license
See http://www.tux.org/lkml/#export-tainted for information about
tainted modules
Module e2 loaded, with warnings
After this , I tried the following commands
#ifconfig hsb0 up
#dhcpcd -n hsb0
But the modem light is not blinking.
Should I install Mandrake 10.1. I have heard that it has support for USB modems.
Thanks a lot
Hi,
--- Neha Narkhede <neha.narkhede@xxxxxxxxx> wrote:
I tried the instructions in the README. But after
typing
# ifconfig hsb0 up
# dcpcd hsb0
What happened when you tried the instructions prior to
the above?
Please provide detailed error/output messages for all
the steps that you followed, so we can find out where
it failed.
SK
--
Shakthi Kannan, MS
Software Engineer, Hexaware Technologies
[E]: cyborg4k@xxxxxxxxx [M]: (91) 98407-87007
[W]: http://www.shakthimaan.com [L]: Chennai, India
__________________________________________________
Do You Yahoo!?
Tired of spam? Yahoo! Mail has the best spam protection around
http://mail.yahoo.com
