[PCB_FORUM] Re: properties... is there a way to see the propertie s on nets/vias/clines?

Make sure your Spacing rule set>Set DRC modes>minimum BB via gap is set to
always

Ann Pelcha  CID
Tektronix Inc.
MBD-Central Engineering
PO BOX 500/ms 39-512
Beaverton, OR 97077-0001 

Phone: 503-627-3142 

Fax:   503-627-5587
(E-mail) - < mailto:ann.m.pelcha@xxxxxxx> 

"Any ideas or opinions expressed here do not necessarily reflect the ideas
or opinions of my employer."

 


-----Original Message-----
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Gene Carman
Sent: Thursday, June 23, 2005 3:48 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] properties... is there a way to see the properties on
nets/vias/clines?

Is there a way to report the properties effecting a particular via or route.
I was just shocked to see two vias on different nets way too close together
with out a DRC.  I checked the spacing rules and there doesn't appear to be
any rule that would allow these to be that close, and yet there they were. 

I want to find all the properties or rules that these vias are supposed to
be following... and try to find what is allowing vias this close without a
DRC.

I must have some logical conflict somewhere... But I don't see it.

Just for the record, this is a 5-6 microvia that was within 1 mil of a 2-5
drilled via, and they were on different nets... there should have been DRC
on layer 5.

Any suggestions?  
-----------------------------------------------------------
To subscribe/unsubscribe: 
        Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
        with a subject of subscribe or unsubscribe

To view the archives of this list please login at
http://www.freelists.org. Our list name is icu-pcb-forum
or go to http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
        Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx

Want to post a job listing ?  DON'T DO IT HERE!  
Better yet, join our jobs listing forum.

SUBSCRIBE:  icu-jobs-forum-subscribe@xxxxxxxxxx
POST:       icu-jobs-forum@xxxxxxxxxx
-----------------------------------------------------------
-----------------------------------------------------------
To subscribe/unsubscribe: 
        Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
        with a subject of subscribe or unsubscribe

To view the archives of this list please login at
http://www.freelists.org. Our list name is icu-pcb-forum
or go to http://www.freelists.org/archives/icu-pcb-forum/

Problems or Questions:
        Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx

Want to post a job listing ?  DON'T DO IT HERE!  
Better yet, join our jobs listing forum.

SUBSCRIBE:  icu-jobs-forum-subscribe@xxxxxxxxxx
POST:       icu-jobs-forum@xxxxxxxxxx
-----------------------------------------------------------

Other related posts: