[PCB_FORUM] Re: orcad 16 back to 15.7
- From: sjchar3@xxxxxxxxxxxx
- To: icu-pcb-forum@xxxxxxxxxxxxx
- Date: Fri, 25 Sep 2009 11:21:35 -0400
HTH, thanks for your response, In 16.2 I?changed reference designators only. I
then opened 15.7 and?reloaded schematic?in 15.7 and did a file save as
"xxs.sch", then sent it to board?house. I hope i don't have any issues later.
Thanks
Sam
-----Original Message-----
From: rjbzxr@xxxxxxxxxxxx
To: icu-pcb-forum@xxxxxxxxxxxxx
Sent: Thu, Sep 24, 2009 1:38 pm
Subject: [PCB_FORUM] Re: orcad 16 back to 15.7
Sam,
Shouldn't be any issue's moving the OrCAD Schematic capture back from 16.2 >
15.7.
1 Note of caution..? You are able to "Reset the Location" of Pin Number's on
Schematic symbols in version 16.x
this was a new feature and is not backwards compatible.
If you have done this to any of your symbols in an existing schematic design
*.dsn then you have to remove them back to
the library defaults.
You do this by clicking on the design name in your project area, then goto the
File > SaveAS
as in the attached snapshot.
If you have never performed Pin Location moving on Schematic symbols then you
would not see this dialog.
HTH.
-----Original Message-----
From: sjchar3@xxxxxxxxxxxx
To: icu-pcb-forum@xxxxxxxxxxxxx
Sent: Thu, Sep 24, 2009 12:15 pm
Subject: [PCB_FORUM] orcad 16 back to 15.7
group:
?
I know allegro pcb 16.2 isn't backward compatible to 15.7, but i can read a sch
saved with 16.2 into 15.7, does anyone know if that will create problems?
?
TIA Sam
Other related posts:
