Are you in Allegro "Expert"? -- George Patrick Tektronix, Inc. Central Engineering, EDS Applications Support P.O. Box 500, M/S 39-512 Beaverton, OR 97077-0001 * 503-627-5272 (voice) * 503-627-5587 (fax) <http://www.tektronix.com/> http://www.tektronix.com <http://www.pcb-designer.com/> http://www.pcb-designer.com "Off-Grid and Proud of it!" -----Original Message----- From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Dharma Kemp-Bresett Sent: Tuesday, January 29, 2008 08:46 To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] "include backdrill" command/property missing? Hello everyone, We are trying to use the "new" backdrill feature in 15.7 and have found that when we get to the nc drill the checkbox for "include backdrill" is not there. It isn't just grayed out, its not there at all, but there is a space for it....We checked version 16.0 and found the same issue. All other backdrill commands/options appear to be there just not that one. Do we have to have expert or something else to get that or are we not doing something during prep that might enable it? Thanks in advance, Dharma KAW/USA Ltd. 39 Simon Street, #4 Nashua, NH 03060 603-886-8711 x212 603-881-8763 fax Confidentiality Notice: This email and any accompanying documents contain information that is confidential, privileged or exempt from disclosure under applicable law and is intended for the exclusive use of the addressee. This information is private and protected by law. If you are not the intended recipient, or have received this email in error, you are hereby notified that any disclosure, copying, distribution or use of the contents of this document in any manner is strictly prohibited.