[PCB_FORUM] Re: from amin
- From: "David Greig" <david@xxxxxxxxxxxxxx>
- To: <icu-pcb-forum@xxxxxxxxxxxxx>
- Date: Tue, 12 Apr 2005 09:30:37 +0100
Amin
Define top (pad only on begin layer) and bottom (pad only on end layer)
surface pads, each set as blind/buried.
Best Regards
David Greig
_____
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Amin Aslan
Sent: 2005-April-12 10:11
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] from amin
I AM USING CADENCE 15.2 AND I AM DESIGNING AN EDGE CONNECTOR : SMD PINS ON
TOP AND SMD PINS ON BOTTOM. HOW DO I DESIGN AN SMD PIN ON BOTTOM ??
I CANNOR MIRROR PINS..ON SMD PINS THERE IS NO BOTTOM LAYER..... THANKS
AHEAD
--
Virus scanned by Lumison.
--
No virus found in this outgoing message.
Checked by AVG Anti-Virus.
Version: 7.0.308 / Virus Database: 266.9.6 - Release Date: 4/11/2005
Other related posts:
