I have a complet design design ready to go into prodcution. It is allready delayed 2 days due to some mysterious non plated hole additional spacing my PCB manufactor demands. (I'm still waitng for them to tell me why). So I had to go in and modify all symbols containing non plated holes. I added the required route keepout around all non plated holes. Then I have update the changed symbols. But my most complex symbols fails the update with the following message: Attempting to refresh symbol 'BGA757_P1MM_40MM_SOCKET'. ERROR: Unable to load symbol, 'BGA757_P1MM_40MM_SOCKET': 'No match found for subclass name.'. I have checked the subclasses in both the symbol and the board and can't find any non matching subclass. Any ideers ?? best regards Peter Sørensen MTS Engineer Ethernet Product Group Vitesse Semiconductor Corporation Location: Denmark Tlf +45 4485-5996 Cell +45 4050-7098 Fax. +45 4485-5939 ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list please login at //www.freelists.org. Our list name is icu-pcb-forum or go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx Want to post a job listing ? DON'T DO IT HERE! Better yet, join our jobs listing forum. SUBSCRIBE: icu-jobs-forum-subscribe@xxxxxxxxxx POST: icu-jobs-forum@xxxxxxxxxx -----------------------------------------------------------