The easiest way I found is cut and paste the coordinates of the via in to the placement of the rat-t. That's copy the coordinates form the "show element" via, paste into the move rat-t pick box. Also, If you drop a rat-t close to the center it should snap to the center of the via. Richard Weinberg Agere Systems 207-846-4539 -----Original Message----- From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of toswanstrum@xxxxxxxxxx Sent: Friday, March 03, 2006 5:44 PM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] Placing Rat T Point Hi all, Is there a way to have a Rat t point snap to the center of via when you place it on the board? Thanks Tom