[PCB_FORUM] Re: Importing orCAD schematics
- From: "westfeldt" <westfeldt_nbcd@xxxxxxxxx>
- To: icu-pcb-forum@xxxxxxxxxxxxx
- Date: Thu, 4 May 2006 16:50:07 -0600
If your customer has v10 or higher, and has your footprint names in the
schematic, then you should have him put out the special allegro netlist set.
Otherwise, there is a fair amount of 3rd party setup you have to do,
including creation of simple device files.
Patrick Westfeldt, Jr.
720-406-0887
_____
From: icu-pcb-forum-bounce@xxxxxxxxxxxxx
[mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Gary MacIndoe
Sent: Thursday, May 04, 2006 4:37 PM
To: icu-pcb-forum@xxxxxxxxxxxxx
Subject: [PCB_FORUM] Importing orCAD schematics
Hey guys,
Sorry if this has been covered lately.
I have been asked to do a small design for Marketing (!?!), and they, for
some reason, use orCAD for schematic capture. It has been years since I
imported anything but Concept HDL.
So in the Import Logic window, Other tab, do you just point to the orCAD
netlist (?) in the "Import netlist:" field? Anything else or is just that
simple?
Thanks for any help!
Gary E. MacIndoe
PCB Design Engineer
Advanced Micro Devices
Longmont, Colorado
Other related posts:
