[PCB_FORUM] How do I avoid long stubs when making copper balancing using a dynanmic area in Allegro 15.2 S80

Hi everyone.
 
I'm searching for a way to do copper balancing using a dyn copper area.
My problem is a lot of long stub between traces.I would like them removed.
Raising the clearence in the shape between shape and lines to a large number 
like 2 millimeter would do it but then the shape can not connect 
connecto to all my GND pins and via's which do have a trace near by.
 
Removing / stiching the stubs with via's is a large manuel job and it must be 
possible to do this in a more efficient way.
 
Any ideers?
 
Peter Sørensen 
MTS Engineer 
Ethernet Product Group 
Vitesse Semiconductor Corporation 
Location: Hørkær 16, 2730 Denmark 
Tlf    +45 4485-5996 
Cell  +45 4050-7098 
Fax. +45 4485-5939

Other related posts: