[PCB_FORUM] Re: Drill Chart on Allegro 15.2
- From: Michael.Catrambone@xxxxxxxxxx
- To: icu-pcb-forum@xxxxxxxxxxxxx
- Date: Thu, 16 Jun 2005 08:29:03 -0500
Oleg,
It does not appear to be any way to revert back to the
Pre SPB15.2 NcDrill Legend subclass separation for Legend
and drill figures.. To avoid any extra work I would suggest
modifying NC Drill Template file (*.dlt) such that the title
specifies that the Drill chart is for reference and the drill
tape should be used. These configuration files are located in
the Cadence software Install directory under share\pcb\text\nclegend.
Here is an example of what you could change in the default-mil.dlt:
(Note only the top of file is shown with ?Title and ?TitleHeight lines
updated)
(make__ncTemplate_struct
?Name "default-mil"
?Title "REFERENCE DRILL CHART: $lay_nams$|PLEASE REFER TO
NC DRILL TAPE"
?Units "mils"
;
; Precision specifies the number of decimal digits to follow the
; decimal point in size and tolerance values appearing in the table.
;
; -1 = as many as are needed ... minimum 1 (DEFAULT)
; 0 = suppress decimal point and decimal digits
; >0 = always put <n> decimal digits after the decimal point,
; adding any trailing 0's as necessary
;
?Precision -1
;
?TitleHeight 400
?TitleTextBlock 9
?ColumnTitleTextBlock 9
?DataTextBlock 9
?PlatingOrder "PlatedFirst"
Hope this helps,
Michael Catrambone
UTStarcom, Inc.
Please respond to icu-pcb-forum@xxxxxxxxxxxxx
Sent by: icu-pcb-forum-bounce@xxxxxxxxxxxxx
To: "'icu-pcb-forum@xxxxxxxxxxxxx'" <icu-pcb-forum@xxxxxxxxxxxxx>
cc:
Subject: [PCB_FORUM] Drill Chart on Allegro 15.2
Hello Allegro Gurus,
Our pcbfab vendor does not require to have Drill Chart table on drill
gerber
layer
(they use drill tape),
there fore before Allegro V15.2 we just turn OF Ncdrill_Legend layer.
Now (on Allegro V15.2) program creates as a default Nclegend1-6 layer and
puts Drill Chart and Ncdrill figures on the same (Nclegend1-6) layer.
So question is: is the way to put Drill Chart on different layer (in order
not to
show it for fabvendor)? Other wise I have to delete Drill chart and leave
Ncdrill figures only before creating gerber.
Thank you in advance.
Regards,
OLEG KIPNIS
x8286
PCB Layout Designer
SMART Modular Technologies, Inc.
4211 Starboard Drive
Fremont, CA 94538
Direct: 510-624-8286 Fax: 510-624-8195
-----------------------------------------------------------
To subscribe/unsubscribe:
Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx
with a subject of subscribe or unsubscribe
To view the archives of this list please login at
//www.freelists.org. Our list name is icu-pcb-forum
or go to //www.freelists.org/archives/icu-pcb-forum/
Problems or Questions:
Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx
Want to post a job listing ? DON'T DO IT HERE!
Better yet, join our jobs listing forum.
SUBSCRIBE: icu-jobs-forum-subscribe@xxxxxxxxxx
POST: icu-jobs-forum@xxxxxxxxxx
-----------------------------------------------------------
Other related posts:
