It takes about 30 seconds to correctly create a room. Jim S. Wages SR PCB Layout Designer -----Original Message----- From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Joe Witten Sent: Wednesday, September 09, 2009 5:14 PM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] Automated room boxes Does anyone know if there is a way for Allegro to automatically generate room boxes based on ROOM properties in the board?...or a script that will make them? Quick place by Room is great, but would be better if there was a way to automate the rooms. Thanks, Joe ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx ----------------------------------------------------------- ----------------------------------------------------------- To subscribe/unsubscribe: Send a message to icu-pcb-forum-request@xxxxxxxxxxxxx with a subject of subscribe or unsubscribe To view the archives of this list go to //www.freelists.org/archives/icu-pcb-forum/ Problems or Questions: Send an email to icu-pcb-forum-admins@xxxxxxxxxxxxx -----------------------------------------------------------