While we're on that topic (or close anyway), what does the final barrel size come to when you have a 20 mil pad (on all layers), 10 mil FHS, and 26 mil anti-pad? Is there a formula for figuring final barrel size? Seems like I've seen one, but can't find it. Thanks in advance. ________________________________ From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Gerry Meier Sent: Friday, December 14, 2007 10:48 AM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] Re: Anti-pads 16 mil over the drill size - 10 mil drill 26 mil anti-pad Gerry Meier, Sr. PCB Designer Freedom CAD Services. Inc Voice: (256)776-7470 or (603) 864-1350 Email:gerry.meier@xxxxxxxxxxxxxx visit us at http://www.freedomcad.com ________________________________ From: icu-pcb-forum-bounce@xxxxxxxxxxxxx [mailto:icu-pcb-forum-bounce@xxxxxxxxxxxxx] On Behalf Of Macindoe, Gary Sent: Friday, December 14, 2007 12:28 PM To: icu-pcb-forum@xxxxxxxxxxxxx Subject: [PCB_FORUM] Anti-pads Hey guys, We haven't thrown around anti-pads for a while! What is the smallest anti-pad for an inner plane that you have successfully used? Has anyone used down to 5 mils a side anti-pad to pad? Thanks, Gary Gary E. MacIndoe PCB Design Engineer Fort Collins, Colorado amd.com gary.macindoe@xxxxxxx This correspondence and any attachments are considered confidential. If you are not the intended recipient, please notify Freedom CAD Services, Inc. immediately by either replying to this message or by sending an email to operations@xxxxxxxxxxxxxx; please destroy all copies of this message and any attachments. Thank you.