I was just recently looking at that myself.
from B0400FA - Rev R ; DIN Rail Mounted Subsystem U G
pg 44
Vertical mounting baseplate P0914XB Revision E is compatible with FCP270s,
ZCP270s,
FCM100Ets and FCM100Es. Earlier versions of the vertical mounting baseplate
P0914XB,
Revision A to D, must be upgraded using kit AG100YB. P0914XA can be replaced
with the
vertical mounting Modular Baseplate (P0926JM) and P0926XB can be replaced
with the
horizontal mounting Modular Baseplate (P0926HT). Replacing P0914XA/B
requires new power
supply cables.
pg 45
When converting from a CP60 system to an FCP270 system, existing P0914XB
(Rev D or earlier)
vertical 8-position baseplates must be replaced using Kit AG100YB.
P0914XB Revision E or later are compatible with FCP270 systems.
Also, it shows up on a Table 3-9 of available horiz and vert. baseplates
without any comment
about revision
So it looks good.
William C Ricker
FeedForward, Inc.
-----Original Message-----
From: foxboro-bounce@xxxxxxxxxxxxx [mailto:foxboro-bounce@xxxxxxxxxxxxx] On
Behalf Of Scott, Joe
Sent: Sunday, November 01, 2015 9:00 AM
To: foxboro
Cc: Johnson, David
Subject: [foxboro] Vertical Base Plate P0926jm RevA
All knowing list,
I know there was a few early vertical base plates that was not upgradeable?
Is P0926JM Rev A RY0546 one of these devices?
Thanks in advance,
Joe
---
This email is free from viruses and malware because avast! Antivirus protection
is active.
https://www.avast.com/antivirus
_________________________________________________________________________
This mailing list is neither sponsored nor endorsed by Schneider Electric
(formerly The Foxboro Company). Use the info you obtain here at your own
risks. See the disclaimer at www.thecassandraproject.org/disclaimer.html
foxboro mailing list: //www.freelists.org/list/foxboro
to subscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=join
to unsubscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=leave
