The compound parameter "INHIB", if set to 1, will also cause the block (all blocks within that compound) to be inhibited. On Wed, Jul 3, 2013 at 8:43 AM, Luciano André Farina <lucfarina@xxxxxxxxx>wrote: > Forwarding an e-mail from a colleague, that had suscribed to the list but > is not able to post, can anybody help on this issue? > ----------------------- > Larissa's question: > > Hello, > > > > I am facing the following problem: some IND blocks have an inhibit alarm > from OPER parameter that I cannot desinhibited. The blocks configuration > has the INHIB=0 AND OP_OPT=0. > > So I expect no alarms at all, but the system shows an inhibit alarm > associate with the OPER parameter. > > Does anyone know how to eliminate this alarm?! > > > > Thank you all in advanced. > > > > Larissa Scherer Severo > __________________________________________________________ > > > > _______________________________________________________________________ > This mailing list is neither sponsored nor endorsed by Invensys Process > Systems (formerly The Foxboro Company). Use the info you obtain here at > your own risks. Read http://www.thecassandraproject.org/disclaimer.html > > foxboro mailing list: //www.freelists.org/list/foxboro > to subscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=join > to unsubscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=leave > > -- Mike Jaudon _______________________________________________________________________ This mailing list is neither sponsored nor endorsed by Invensys Process Systems (formerly The Foxboro Company). Use the info you obtain here at your own risks. Read http://www.thecassandraproject.org/disclaimer.html foxboro mailing list: //www.freelists.org/list/foxboro to subscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=join to unsubscribe: mailto:foxboro-request@xxxxxxxxxxxxx?subject=leave