George, No unfortunately the number is not appearing on the next line. I will try using the escape codes set up that you suggested. Thank you, Lisa Heberger Alternative Media Center Braille Specialist mailto:lisa.e.heberger@xxxxxxx Phone: (804) 916-8862 ________________________________ From: duxuser-bounce@xxxxxxxxxxxxx [mailto:duxuser-bounce@xxxxxxxxxxxxx] On Behalf Of George Bell Sent: Friday, March 01, 2013 4:50 PM To: duxuser@xxxxxxxxxxxxx Subject: [duxuser] Re: questions about page numbers using the Juliet pro 60 Hi Lisa, Does the rest of the number appear on the start of the next line perhaps? I'm just wondering if its page width related? I usually make sure embossers are set in Global Embosser Setup to allow Escape Codes, rather that pre-set the embosser. George. From: duxuser-bounce@xxxxxxxxxxxxx [mailto:duxuser-bounce@xxxxxxxxxxxxx] On Behalf Of Heberger Lisa E Sent: 01 March 2013 20:29 To: duxuser@xxxxxxxxxxxxx Subject: [duxuser] questions about page numbers using the Juliet pro 60 good afternoon all, I have a publication that I have formatted to show both print and Braille page numbers and I can see them on the Braille display so I know that all is well there. However the Juliet pro has decided to show page numbers intermittently. For instance I may see the page number on the top right and not the bottom left or just the number sign on the bottom. does anyone know why this might be happening? If anyone can help I would appreciate it. Thank you, Lisa Heberger Alternative Media Center Braille Specialist mailto:lisa.e.heberger@xxxxxxx Phone: (804) 916-8862