In that case, plug in the controller in to port a's in, and then the module on port a's out. HTH, D!J!X! _____ From: ddots-l-bounce@xxxxxxxxxxxxx [mailto:ddots-l-bounce@xxxxxxxxxxxxx] On Behalf Of Omar Binno Sent: Tuesday, October 28, 2008 12:07 AM To: ddots-l@xxxxxxxxxxxxx Subject: [ddots-l] Re: midi setup question the controler will be controling the module as well as my softsynths. Omar Binno AIM: LOD1116 Skype: obinno1 Website: www.omarbinno.com ----- Original Message ----- From: D!J!X! <mailto:megamansuperior@xxxxxxxxxxx> To: ddots-l@xxxxxxxxxxxxx Sent: Monday, October 27, 2008 10:14 PM Subject: [ddots-l] Re: midi setup question do you want the roland controller to controll the module? if so why not just plug controller out in to module in? or else plug controller out in to 2x2 in, and module in into 2x2 out...this is how i would do it, if I'm understanding u right... HTH, D!J!X! _____ From: ddots-l-bounce@xxxxxxxxxxxxx [mailto:ddots-l-bounce@xxxxxxxxxxxxx] On Behalf Of Omar Binno Sent: Monday, October 27, 2008 7:42 PM To: ddots-l@xxxxxxxxxxxxx Subject: [ddots-l] midi setup question Hi Everyone, I have a midi controler and a roland Module. I'll be connecting both via a midiman 2x2 midi interface. I haven't used this setup in quite a while, and want to make sure I have the midi wire configuration correct. I would have 1 midi wire running from the "midi out" of the controler into the "midi in" of the interface, and I would have 1 midi cable running from the "midi out" of the module into the "midi in" of the interface. Is this correct? Thanks. Omar Binno AIM: LOD1116 Skype: obinno1 Website: www.omarbinno.com