On 07 Sep, A Rawnsley <rcomp@xxxxxxxxxxx> wrote: > In message <52cb6f17f2ARMini@xxxxxxxxxxxxxxxxxxxx> > John Greenwood <ARMini@xxxxxxxxxxxxxxxxxxxx> wrote: > > I have a Disgo memory stick which I have formatted to FAT32 and put a > > couple of files on a PC. > > When I plug this into the ARMini nothing happens. If I run !USBinfo an > > icon appears on the bar which gives information about the device but > > not access to the contents. > > How do I read USB memory? > Firstly, are you sure it is FAT32 formatted? Most PC systems these > days don't make it very easy to format to FAT32, so I'm a little > concerned that you "formatted" the stick - it should have come > pre-supplied as FAT32. Yes I reformatted it to ensure a clean start to my tests and selected the FAT32 format option However.... > Oh, and one last thing - how big is your USB disc? FAT32 is normally > used for 2Gb+, which practically all USB sticks are. However, if you > have a really old one, it could be smaller than that. If that's the > case, I'd gently recommend ditching in favour of a 2Gb+ one which > should cost around five pounds. If you *must* use <2Gb, you may find > it necessary to RMKill FAT32FS as DOSFS can work better for teeny > drives. But, as I said, I *really* recommend using >2Gb drives. I have just tried it with a 4 GB stick and it worked! (Before I had been trying with a 250MB one) Thanks again John -- John Greenwood Bsc CEng FIEE www.john-greenwood.co.uk --- To alter your preferences or leave the group, visit //www.freelists.org/list/armini-support List-related queries to info@xxxxxxxxxxxx